具有低 RDSon 的 100W 立體聲、200W 單聲道、0V 至 34V 電源電壓、PWM 輸入開環(huán) D 類音頻放大器
| Audio input type | PWM |
| Architecture | Class-D |
| Speaker channels (Max) | 4 |
| Power stage supply (Max) (V) | 13.2 |
| Power stage supply (Min) (V) | 10.8 |
| Load (Min) (ohms) | 2 |
| Output power (W) | 100 |
| SNR (dB) | 110 |
| THD + N @ 1 kHz (%) | 0.09 |
| Iq (Typ) (mA) | 5.6 |
| Control interface | Hardware |
| Closed/open loop | Open |
| Analog supply (Min) (V) | 10.8 |
| Analog supply (Max) (V) | 13.2 |
| PSRR (dB) | 65 |
| Operating temperature range (C) | 0 to 70 |
- Total Power Output (Bridge Tied Load)
- 2 × 100 W at 10% THD+N Into 4 Ω
- 2 × 80 W at 10% THD+N Into 6 Ω
- 2 × 65 W at 10% THD+N Into 8 Ω
- Total Power Output (Single Ended)
- 4 × 40 W at 10% THD+N Into 3 Ω
- 4 × 30 W at 10% THD+N Into 4 Ω
- Total Power Output (Parallel Mode)
- 1 × 200 W at 10% THD+N Into 2 Ω
- 1 × 160 W at 10% THD+N Into 3 Ω
- >110 dB SNR (A-Weighted With TAS5518 Modulator)
- <0.1% THD+N (1 W, 1 kHz)
- Supports PWM Frame Rates of 192?kHz to 432?kHz
- Resistor-Programmable Current Limit
- Integrated Self-Protection Circuitry, Including:
- Under Voltage Protection
- Overtemperature Warning and Error
- Overload Protection
- Short-Circuit Protection
- PWM Activity Detector
- Standalone Protection Recovery
- Power-On Reset (POR) to Eliminate System Power-Supply Sequencing
- High-Efficiency Power Stage (>90%) With 110-mΩ Output MOSFETs
- Thermally Enhanced Package 44-Pin HTSSOP (DDV)
- Error Reporting, 3.3-V and 5-V Compliant
- EMI Compliant When Used With Recommended System Design
The TAS5342LA is a high-performance, integrated stereo digital amplifier power stage designed to drive a 4-Ω bridge-tied load (BTL) at up to 100 W per channel with low-harmonic distortion, low-integrated noise, and low-idle current.
The TAS5342LA has a complete protection system integrated on-chip, safeguarding the device against a wide range of fault conditions that could damage the system. These protection features are short-circuit protection, over-current protection, under voltage protection, over temperature protection, and a loss of PWM signal (PWM activity detector).
A power-on-reset (POR) circuit is used to eliminate power-supply sequencing that is required for most power-stage designs.
